Dana 44 3.07 gears needed

[irish]

I need a 3.07 ring & pinion (new or used) for my Dana 44 TT I'm going to use in my Cruiser.

Joe

[irish]

stude1964 message sent.

[00RACER]

I have a comlete 3.07 open rear to sell.
THANKS

[woodysrods]

I have a complete rear end also.
But, shipping costs would be the biggest factor.
Maybe someone else is looking that might be closer to me???
Good Roads
Brian

[irish]

Shipping the complete axle could cost more than the axle itself. All I really need is the ring & pinion gear, or just the center section.

Joe

[Roscomacaw]

I recently shipped that 44 from Fresno, Ca to Phoenix, AZ via Greyhound. It weighed 97lbs wrapped and taped and without the axle shafts and it cost
$114 dollars Bus station to Bus station. At roughly 700 miles, that's about 8 cents a mile.

[sweetolbob]

Joe

I went back through your previous posts and you were hedging between a 3.07 and a 3.31. I can't help with the 3.07 but I have a 3.31 (43/13) ring and pinion mounted on an open carrier. It will fit your 44 flanged axle Dana posi carrier as it came from my 74 Avanti. I can pull it off the carrier and just send you the R&P for the cost of shipping if you're interested. If not, the offer is open to anyone else on the forum.

Bob

[irish]

Joe

I went back through your previous posts and you were hedging between a 3.07 and a 3.31. I can't help with the 3.07 but I have a 3.31 (43/13) ring and pinion mounted on an open carrier. It will fit your 44 flanged axle Dana posi carrier as it came from my 74 Avanti. I can pull it off the carrier and just send you the R&P for the cost of shipping if you're interested. If not, the offer is open to anyone else on the forum.

Bob

Thanks Bob!

At that price how can I refuse! Feel free to email me at irishnra@cox.net and we can work out the details.

Thanks,
Joe

[irish]

Bob you have mail.

Joe

[irish]

I'm still looking for some 3.07 gears for a Dana 44

Thanks,
Joe