Merry christmas and happy new year.
Winter in South Bend.
I can't do much else than work on engines and
mechanical stuff.
I dragged out the last 232 shortblock I have and started to
build it up.
Cylinder #7 has about 1" by 1 1/2" rust spot (pin holes).
It is not deep it all.
My first impulse is to have it re-sleeved.
Second option is to bore that cylinder and install a larger piston.
Third is to just clean it up and re assemble.
Has anyone been faced with a similiar problem?
What suggestions do you have as I never had this problem before.
Thanks.
Paul
Winter in South Bend.
I can't do much else than work on engines and
mechanical stuff.
I dragged out the last 232 shortblock I have and started to
build it up.
Cylinder #7 has about 1" by 1 1/2" rust spot (pin holes).
It is not deep it all.
My first impulse is to have it re-sleeved.
Second option is to bore that cylinder and install a larger piston.
Third is to just clean it up and re assemble.
Has anyone been faced with a similiar problem?
What suggestions do you have as I never had this problem before.
Thanks.
Paul
Comment