tomorrow I will be gluing my 64 Lark dash pad onto the metal frame. The frame is painted and ready to go. The pad is clean and standing by.
I trial fit the pad and there are so many things that need lined up I am concerned. The pad needs centered around the gage cluster opening, it needs aligned with the speaker cutout and bolt holes, and the glove box width/opening needs to be spread for the door to fit.
I am nervous because it will take me a bit time to make sure all of this is positioned correctly before the glue dries. I am going to use 3M Spray Glue Adhesive and it will be 70-75 degrees tomorrow.
Do I have much time to work before the glue sets (the can says 30 seconds to 20 minutes)? That 30 seconds number scares the heck out of me.
Lastly, any tips from those who have done this before. I get one shot at it so I hope I get it right.
Thanks, Jeff
I trial fit the pad and there are so many things that need lined up I am concerned. The pad needs centered around the gage cluster opening, it needs aligned with the speaker cutout and bolt holes, and the glove box width/opening needs to be spread for the door to fit.
I am nervous because it will take me a bit time to make sure all of this is positioned correctly before the glue dries. I am going to use 3M Spray Glue Adhesive and it will be 70-75 degrees tomorrow.
Do I have much time to work before the glue sets (the can says 30 seconds to 20 minutes)? That 30 seconds number scares the heck out of me.
Lastly, any tips from those who have done this before. I get one shot at it so I hope I get it right.
Thanks, Jeff
Comment