PDA

View Full Version : Lark heading for crusher- oregon



63 R2 Hawk
03-31-2017, 07:09 PM
This poor Lark is not salvageable but there are a few usable parts on it. Located in a junk yard in Independence, Oregon. PM me if you'd like to know where it's at, rear bumper is decent, driver fender didn't look too bad from what I could see of it and hood is fair. Most of the glass looks OK. Has a259, generator is still on it. Floor & frame are gone....

8E45E
03-31-2017, 07:26 PM
See if those rear window regulators are okay and not stripped. I know it's WORK to get at them, but they are hard to find!

Craig

57pack
03-31-2017, 09:03 PM
The red MGB-GT behind the Lark looks to be decent, has wire wheels.

63 R2 Hawk
04-01-2017, 12:27 AM
See if those rear window regulators are okay and not stripped. I know it's WORK to get at them, but they are hard to find!

Craig
Maybe a job for an air chisel.....

8E45E
04-01-2017, 05:54 AM
Maybe a job for an air chisel.....

Actually, its removing almost all the rear of the interior to get at them, meaning the seats and inside panels. And then to disconnect the glass from the regulator itself, which is all the work. Its only four bolts once one gets to them, so I don't think an air chisel would speed things up any.

Craig

candbstudebakers
04-01-2017, 09:56 AM
The front ones from a hardtop are harder to find and easier to get out. Also the wing vent windows are of some value, and hard to find.

StudeRich
04-01-2017, 04:24 PM
Basically ALL of the Mouldings are hard to find for Hardtops in good condition, Belt Mouldings; Chromed Castings and Stainless.