Results 1 to 5 of 5

Thread: Drive shaft center bearing spline shaft seal

  1. #1
    Champion Member
    Join Date
    Oct 2016
    Location
    Wa
    Posts
    10

    Drive shaft center bearing spline shaft seal

    Shop manual calls for a cork grease washer. Any one using neoprene or some other than cork?

  2. #2
    President Member
    Join Date
    Jan 2006
    Location
    Joliet , Illinois
    Posts
    2,867
    There are teeth in the washer and would be hard to make.

  3. #3
    President Member (S)'s Avatar
    Join Date
    Aug 2010
    Location
    Ferndale, Washington
    Posts
    2,132
    Use paper gasket material. Lay a piece over the washer and pres hard, you may get a good enough imprint to cut a pattern. The thin stuff may work better, and you may need 2.

  4. #4
    Champion Member
    Join Date
    Oct 2016
    Location
    Wa
    Posts
    10
    This is a 55 Commander, the pt no is 522053 and SI says no stock. So need to come up with something.

  5. #5
    Commander Member
    Join Date
    Jul 2015
    Location
    Tempe, AZ
    Posts
    68
    I used an o-ring as described in this thread: http://forum.studebakerdriversclub.c...ht=spline+seal
    Seems to work fine.
    3H-C5 "The Blue Goose"


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •