Announcement

Collapse
No announcement yet.

63 Lark ignition problem

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • #16
    Connect a ground jumper cable direct to the starter and see if that changes anything.

    Comment


    • #17
      The last time I had this problem in my Avanti the car ended up "dead" on the side of the road. I knew it was going to happen because I had the same symptoms as the OP but I kept putting off the fix. After finally getting the car home I simply replaced the ignition switch. I had an old Lark switch on a shelf so I pulled the key and tumblers out of the failed switch and put them in the "new" one. All is good now and I am even using my original keys.

      Comment

      Working...
      X