View Full Version : Repro parts for '41 Commander?

05-20-2015, 06:20 PM
Hi All. Just wondered if anyone was manufacturing knobs and switches for my 41 Commander? I have a variety of them on my dash at the moment.

05-20-2015, 06:36 PM
For a Part to be reproduced it usually has to have a Large Quantity need, that does not sound like one to me.
However it is all about the Cost to produce it, this one may not be too expensive to do, so you never know.

I believe Schrock Bros. do make some fairly rare Knobs.

Are you saying you have extra Original Type Knobs that could be used as samples, or you have all the wrong ones on your Car and need some correct ones?

05-20-2015, 06:37 PM
Try Shrock Brothers they have many reproduction parts available.

05-20-2015, 07:48 PM

05-21-2015, 08:44 AM
Thanks Everyone. what I have at the moment ranges from the 40's to the 70's and I suspect only one of them is original

05-21-2015, 09:29 PM
Richard Quinn (Studebaker Wheel) helped me out on a knob or two when i purchased by '40 Champion. pics would help find what is needed.

also, a post here may help: http://forums.aaca.org/forum/21-studebaker-erskine-rockne/