PDA

View Full Version : '53 Fiberglass Body - Custom Chassis project for sale - $8500



hausdok
01-02-2014, 06:14 PM
http://milwaukee.craigslist.org/pts/4247004192.html

53commander
01-02-2014, 06:20 PM
That is pretty interesting but for the amount of work needed to finish versus the price I think it would be better to start with an original driver. Unless a total glass shell is your thing.

Flashback
01-02-2014, 06:21 PM
Man, If I had that and about a million dollars to go with it. I coud catch up with Jeff

junior
01-02-2014, 08:17 PM
Man, If I had that and about a million dollars to go with it. I coud catch up with Jeff

ya, drag racer is what I was thinking too, but not being an expert it sure doesn't look like a race car frame to me...and if its intended to be a street driven rod, there sure is a lot of work to be done to it. I don't get where the driveshaft is supposed to go through that crossmember, looks like there is space left for a street exhaust system but no drive train and is there room for serious rear rubber? looks like good work, just confused as to the intention of application. cheers, junior.

jimmijim8
01-03-2014, 05:59 AM
Pig in a poke perhaps. That is over my head. May be just right for a competent visionary. cheers jimmijim

evilhawk
01-03-2014, 10:54 AM
I think this car was being built as a street rod and I bet that fiberglass shell weighs as much or more than a steel one. They do make lighter shells for drag racing, but I doubt this is one of them.

t walgamuth
01-04-2014, 07:45 PM
frame looks kindof small to me.