The tacho in my 1971 Avanti 11 is acting strangely. As soon as I turn on the ignition, the needle goes all the way round past 8000 RPM and stays there until switched off. It has done this since I have owned it. Yesterday while out driving on the freeway, the needle started moving back and forward and gradually heading down to somewhere near it should be. Hit a bump, and back to the end stop again. It did not actually sit steadily on rpm, but moved around it for a short while, but now it's back to flat out. Any ideas? A bad earth perhaps. This car has been converted to right hand drive, so under the dash, it's all over the place
Thanks in advance,
Dave...
Thanks in advance,
Dave...
Comment