Did Studebaker make/use a flat block off plate on the rear of the right head to block off the coolant if no heater/defroster was installed?
I was expecting to find some threaded fittings that I could cap or plug. But that fitting is one piece cast with a nipple on the end. The previous owner had a short piece of hose with a plug clamped in. Is that about the best I can do? At least the water pump had a threaded fitting I can replace with a plug.
Paul
I was expecting to find some threaded fittings that I could cap or plug. But that fitting is one piece cast with a nipple on the end. The previous owner had a short piece of hose with a plug clamped in. Is that about the best I can do? At least the water pump had a threaded fitting I can replace with a plug.
Paul
Comment