PDA

View Full Version : D & M Restorations



JER
03-05-2012, 07:10 PM
Any of you guys in the Greenville, S.C. area know of this shop. They advertise as America's finest classic instrument restoration shop.
I called them and they said they could repair my fuel gauge for the Hawk.
Any feed back on this place?

64V-K7
03-06-2012, 04:43 AM
I've heard of D&M doing excellent work back into the late 90's

VAG88
03-06-2012, 12:17 PM
JER: I,had D&M,restore and convert a clock for my 1963 Lark.I,haven't installed it yet,but it looks like new.They,are very good communicators,and kept me informed of progress as it went along. I,have no doubt,it will operate,just fine. VA88

SILENTBOB
03-06-2012, 03:42 PM
They did the speedometer on my 64 Avanti and it looks like new.

jclary
03-06-2012, 03:48 PM
Any of you guys in the Greenville, S.C. area know of this shop. They advertise as America's finest classic instrument restoration shop.
I called them and they said they could repair my fuel gauge for the Hawk.
Any feed back on this place?

Get me an address and I'll be happy to drop by and check them out.

bezhawk
03-06-2012, 05:28 PM
I called them to do some gauges for me, but, was told I had a year wait.
(I couldn't wait a year).

JER
03-06-2012, 10:40 PM
I called them to do some gauges for me, but, was told I had a year wait.
(I couldn't wait a year).

Sounds about right. They have had my gas gauge and sending unit for over a month and had not worked on it yet. Called three weeks ago and was told it was next in line and would call in about a week. No call so I called again this morning and was told it was next in line. Their ad in Hemming's said fast turn around!

JER
03-06-2012, 10:44 PM
Get me an address and I'll be happy to drop by and check them out.

D&M Restoration
57B Creekside Park Ct
Greenville, S.C.
864 254 9989

okc63avanti
03-06-2012, 10:50 PM
When my entire set of Avanti Stewart Warner gauges were restored I used Williamson's Instrument Service located in Chester, Arkansas. The work was excellent and the gauges were turned around in a couple of months. I'm not sure what their timing or backlog is looking like currently but I seemed to have hit them at a good time.

http://www.williamsons.com/