Cylinder head help

[Flashback]

Would someone who has a 259 or 289 head handy, give me the port sizes (measurements)
on the exhaust ports ? Thanks a lot

[(S)]

Sure, the ORIGINAL Steel Victor Gasket openings are very close (slightly larger) than the Port Size, the ENDS are: 1 3/16 in. Wide X 1 11/16 in. Tall,
The Center are: 1 3/4 in. Wide X 1 5/16 in. Tall.

The 232's are very Low, not as tall.

[Flashback]

Thanks a lot. I didn't have one out where I could measure it. This answers the header question for me.
Thanks again for taking time to do this.