PDA

View Full Version : Stumbled into a pair of Daytonas



TX Rebel
02-22-2011, 01:12 PM
I attended a local swap meet
on Sat, & found what would be a really cool car if it were not eaten up with rust: A '62 Daytona which still had its original 289 4V, 4-spd & TT. It came with some good NOS sheetmetal, and extra parts so when the seller offered to deliver it to my place, I could not resist. Then yesterday a friend called to tell me that he had a very solid W TX 63 Daytona body he wanted to sell. He delivered it today, & accepted a solid rear fender for his 51 Starlight in partial trade.
It's even set up for a standard shift. Between the 2, I have the makings of a sweet car. The only down side is that I will be too broke to attend the Decatur TX swap meet this weekend.

starliner62
02-22-2011, 02:24 PM
Some guys have all the luck!!!

ozarkman
02-23-2011, 08:49 AM
Pictures please! ;)

AKAchamptrucking
02-23-2011, 10:05 AM
My gawd man!! Pictures!!!

Bob Andrews
02-23-2011, 03:11 PM
Amazingly similar to my situation!

A few years back I bought this Daytona off eBay. 289 4V 4-speed. Complete but completely rusted, engine stuck. Rustiest Texas car I've ever seen:p:

7556

Same seller also listed this one. Very nice 259 Auto, engine also stuck. Native NE car but amazingly sound- even the original carpet is nice! Has beautiful dash, door panels, and headliner. Buckets are nice but need new covers. No rust in the floors, frame or trunk. Only rust anywhere is the front fenders:

7557

The seller (now my good friend John Batka) had intended to combine the two into one car. I bought them both at the same time thinking the same thing.

Turned out the AT car is nice enough that I didn't really want to break it down and change it over. While I was thinking it over I found this one in MI:

7558

It's a CO 4-speed body. No running gear or interior but beautiful floors and frame. I bought the car along with inner and outer fenders, hood, trunk, header, a bunch of trim, etc.- all NOS!

Meanwhile, I bought this Skytop from Kent Fedor, also in MI. 6 auto with a rod knock. Victim of fiberglas repairs on rusted areas. It was the so rusted it was breaking apart. I bought it for the roof, which is stored away for the above project:

7559

Since then I had some bumps in the road, and the project is on hold. I do keep picking up pieces for it; the r2 engine for it is complete, fresh, and ready to go, about an hour break-in time. I don't want to do it until I can go all out, from the ground up. So everything is stored away, waiting. Good news is, they don't eat nuthin';)

So there's my pictures- how about some of yours TX?:)