PDA

View Full Version : 1946 M5...oil filter?



BruceT
02-19-2011, 09:40 AM
So I finally got my M5 home from south of the border,and I was poking around the engine compartment to start changing fluids to attempt to start it up and I can't see an oil filter?I can see a location where the oil pressure sensor comes off,but no filter.Some pictures I have seen show a remote kind of filter on the motor on the drivers side,I also brought home a spare engine and tranny from an M15,no filter on it either...was an oil filter an option?My shop manual shows a filter,the parts manual lists a Fram filter...am I blind?

http://gallery.flybc.ca/albums/brucet/IMGP1795.jpg

Corvanti
02-19-2011, 09:47 AM
no filter on my '40 Champion either. the owner's manual mentions: "fittings that permit the installation of a Fram oil cleaner as special equipment"... a dealer installed option???
wouldn't mind having one. until then, i'll be changing the oil at least every 1,500 miles.

BobPalma
02-19-2011, 10:34 AM
Sure, guys; the oil filter was optional at extra cost. In fact, the "Champion" engine didn't get an oil filter as standard equipment until mid-1962, and that was after it had been converted to overhead valves. BP

dictator27
02-19-2011, 11:11 AM
Come to the BC Coastal Chapter meeting this Sunday, Bruce. One o'clock, 211 N. Grosvenor, Burnaby, potluck.

Terry

BruceT
02-19-2011, 11:43 AM
pm sent terry

garyash
02-19-2011, 12:12 PM
Here's how to install the oil filter.

http://www.studegarage.com/images/other/oil_filter_instructions_vsm5.jpg

62champ
02-19-2011, 04:23 PM
I was reminded the other day on an antique tractor forum about oil and old vehicles - the cheapest oil you can buy today is much better than the most expensive oil around when these vehicles were new. And remember, those add on filters were by-pass filters - they did not filter the oil before it went to all those moving parts.

Good luck