PDA

View Full Version : NoRol Unit for 51 Stude Champion



Jerry Johnson
07-20-2006, 11:57 AM
I am attempting to reassemble the NoRol unit on the 51 Stude and am searching for info about one of the parts I cannot buy, the sleeve Illust. Number 1105-9 SLEEVE,Adjusting P/N 188323. Can anyone tell me the ID measurement, wall thickness, and length of this item[?] I am also working on the propeller shaft and have been unable to locate a source for Illust. Number 900-11 WASHER, shaft sleeve grease P/N 522053. I think it's made from cork and if I could find the OD, ID, and thickness measurements I might be able to just make one. If anyone has the measurement info on this part or knows where I might find a more modern replacement gasket I would be very thankful.:D

dpson
07-20-2006, 03:07 PM
Jerry,
I have both those items listed in inventory. I'd need to check on the condition of the 522043 (Washer) as some of the cork items haven't faired well after all these years. If you are interested drop me an email at: dpson1954@adelphia.net

BTW I'll be at the NE Zone Meet in Keene, NH Friday through Sunday.

Regards,
Dan Peterson
Montpelier, VT

1960 Lark Convertible
1962 Lark Regal Convertible

Jerry Johnson
07-23-2006, 01:48 PM
Dan, I am interested and dropped you an email, hope I didn't get spammed out.

Regards,
Jerry

dpson
07-23-2006, 06:30 PM
Jerry,
I got your email and sent a response.
Dan

Dan Peterson
Montpelier, VT
1960 Lark V-8 Convertible
1960 Lark V-8 Convertible (parts car)
1962 Lark V-8 Regal Convertible