PDA

View Full Version : seat screws?



dclewallen
06-11-2006, 04:39 PM
I just recieved some chrome seat hinge covers for my Hawk bucket seats. My frames were blasted and epoxy primered before they were recovered [kind of filled in the threads in the tapped holes] . I have no screws to hold them to the seat frames. So I don't retap them the incorrect size, What is the correct size for these screws? Thanks for the information,

Darryl C. Lewallen

Roscomacaw
06-11-2006, 07:13 PM
Book calls for 10-32X3/4" Darryl ;)

Miscreant at large.

1957 Transtar 1/2ton
1960 Larkvertible V8
1958 Provincial wagon
1953 Commander coupe
1957 President 2-dr
1955 President State
1951 Champion Biz cpe
1963 Daytona project FS

dclewallen
06-11-2006, 08:09 PM
THANK YOU VERY MUCH MR.BIGGS

Darryl C. Lewallen

jimmijim8
06-12-2006, 08:34 AM
Go to your local hardware store and buy the stainless ones. jimmijim

ROADRACELARK
06-12-2006, 09:09 AM
Make sure they're tapered seat and phillips head:)Dan

PalmerGA
06-12-2006, 09:29 AM
I just replaced the plastic/fiberglass ones in my ragtop (benchseat) with the chromed metal ones. I had to put about 1/4 to 3/8 inch of washers between the covers and the mounting frame to keep the seatback from binding when tilted forward for rear seat access. Kind of surprised me, but it seems to work okay.

Jim's pride....
1963 Daytona Convertible

dclewallen
06-12-2006, 05:11 PM
I just returned from my local ACE Hardware with the stainless steel phillips head screws. Forgot the tap. I'll have to make another trip tommorrow. Thanks all,

Darryl C. Lewallen