Hello Everyone,
Well, I finally bought one. It is a 1949 2R10 from what the plate says. Engine 1R-20416.
I guess I have a ton of questions.
Any help is appreciated. I sure do like the look of these.
1) Is this considered a 3/4 ton?
2) Where can I buy the brake tool?
3) Are they better left as stock as possible or are some newer components ok? (12 volt, gauages, etc)
4) Is there any way to find the paint name by the code? P-2204?
5) Any way to find trim information? Trim # 1-6033
6) Can a "normal" machine shop rebuild these engines without issues? Any secrets?
7) It has some small rust holes, what does everyone recommend for repair of these? Fiberglass?
Again, any help is appreciated. I don't want to reinvent the wheel if I can learn from the pros.
Well, I finally bought one. It is a 1949 2R10 from what the plate says. Engine 1R-20416.
I guess I have a ton of questions.
Any help is appreciated. I sure do like the look of these.
1) Is this considered a 3/4 ton?
2) Where can I buy the brake tool?
3) Are they better left as stock as possible or are some newer components ok? (12 volt, gauages, etc)
4) Is there any way to find the paint name by the code? P-2204?
5) Any way to find trim information? Trim # 1-6033
6) Can a "normal" machine shop rebuild these engines without issues? Any secrets?
7) It has some small rust holes, what does everyone recommend for repair of these? Fiberglass?
Again, any help is appreciated. I don't want to reinvent the wheel if I can learn from the pros.
Comment