Need Right Front Wheel Well Moulding

[Anne F. Goodman]

Anybody have the right Front wheel well Molding for a 1957 Golden Hawk?
Please let me know. Thank you
PS Straightened the front hood piece looks good.

Mabel 1949 Champion
1957 Silverhawk
1955 Champion 4Dr.Regal
Gus 1958 Transtar
1955 President State
1957 Golden Hawk
Fresno,Ca

[blackhawk61]

Lots of luck to You Anne ..............Been looking for that same one myself.

1961 Hawk 4BC,4-SPEED,TT

Ken Byrd
Lewisville,NC

[Anne F. Goodman]

Ah I see. I have one but its pretty bad. The rest of them we go straightened up but this one is bad.

Mabel 1949 Champion
1957 Silverhawk
1955 Champion 4Dr.Regal
Gus 1958 Transtar
1955 President State
1957 Golden Hawk
Fresno,Ca

[rockne10]

SI has them restored as a set of four for $495[:0] but you must send them restorable cores to get them. Their part # 801348.

[jimmijim8]

They are not too hard to come by and should run around 35 to 50 for a nice used one. Advertise for one at unofficial studebaker drivers club. lots of used ones out there jimmijim

[Anne F. Goodman]

Thank you

Mabel 1949 Champion
1957 Silverhawk
1955 Champion 4Dr.Regal
Gus 1958 Transtar
1955 President State
1957 Golden Hawk
Fresno,Ca

[candbstudebakers]

Anne I have lot of them nothing perfect but ones that can be repaired , dents removed and buffed, the right side front is the one most are looking for, they are hard to ship can you wait until Sacramento? or take a drive up to the bay area....Bob Peterson ...510-266-2522

[Anne F. Goodman]

I can wait until Sacramento in fact we will be there. Please bring them. Thank you

Mabel 1949 Champion
1957 Silverhawk
1955 Champion 4Dr.Regal
Gus 1958 Transtar
1955 President State
1957 Golden Hawk
Fresno,Ca

[GEEMAC]

Anne; you may try Jon Meyer, I sold him extras i had a few years back. Mac.

[jeryst]

Ann, if you find any good extras, I need the same one too.