Announcement

Collapse
No announcement yet.

How do these ignition switch lights mount?

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
  • #1

    How do these ignition switch lights mount?

    Anybody know how these ignition switch lights mount? Any drawings or pictures?



    I'm sure it's pretty simple...

    Scott Rodgers
    Los Angeles
    SDC Member since 1989
    '60 Lark HT
    '63 Wagonaire
    Scott Rodgers
    Los Angeles
    SDC Member since 1989
    \'60 Lark HT
    \'63 Wagonaire
    \'66 Frankenbaker
    Tags: None
  • #2
    It IS! The light fastens to the switch housing on a small boss that may need to be drilled and or tapped for the light which was not on low-end models.

    You position it so that the spot of light hits the bezel where the hole (on the top) is located, then connect to Instrument light switch, or in case that is not where the factory connected it, check the wiring diagram in the Shop Manual.
    StudeRich
    Second Generation Stude Driver,
    Proud '54 Starliner Owner
    SDC Member Since 1967

    Comment

    • #3
      StudeRich,

      Yes - that makes sense now. I have a reproduction switch bezel now - one w/o the hole. I do remember original ones having that hole though. Thanks.

      Scott Rodgers
      Los Angeles
      SDC Member since 1989
      '60 Lark HT
      '63 Wagonaire
      Scott Rodgers
      Los Angeles
      SDC Member since 1989
      \'60 Lark HT
      \'63 Wagonaire
      \'66 Frankenbaker

      Comment

      Previous template Next
      Working...
      X