Hello:
I am trying to re-install the valve body and rear servo in a transmission I did NOT take apart (someone who I cannot contact did).
I have the "anchor strut" that goes between the servo and the band, but I do not have the "servo anchor" that goes between the servo adjusting screw and the band (these part names are from page 68 of the 56 Studebaker factory shop manual-they could be called something else). Can anyone either sell me a "servo anchor" or tell me where I can locate one? Also, are there gaskets and/or O rings that are required to install these parts?
Thanks very much
Howard Brown
Los Angeles Chapter - Studebaker Driver's Club
I am trying to re-install the valve body and rear servo in a transmission I did NOT take apart (someone who I cannot contact did).
I have the "anchor strut" that goes between the servo and the band, but I do not have the "servo anchor" that goes between the servo adjusting screw and the band (these part names are from page 68 of the 56 Studebaker factory shop manual-they could be called something else). Can anyone either sell me a "servo anchor" or tell me where I can locate one? Also, are there gaskets and/or O rings that are required to install these parts?
Thanks very much
Howard Brown
Los Angeles Chapter - Studebaker Driver's Club