PDA

View Full Version : Voltage Regulator for Avanti



nels
05-05-2008, 06:54 PM
Anybody have an off the shelf # for a 64 Avanti voltage regulator? A solid state unit would be fine.

JDP
05-05-2008, 10:18 PM
On Bob Johnstone's web site there is the part number for the solid state module to install under your old can.

JDP/Maryland

Bob Langer
05-06-2008, 07:48 AM
http://i242.photobucket.com/albums/ff143/regnalbob/scan-5.jpg
http://i242.photobucket.com/albums/ff143/regnalbob/scan0001-3.jpg



Bob Langer
Glenshaw,PA

http://i242.photobucket.com/albums/ff143/regnalbob/cropped-1.jpg

grobb284
05-06-2008, 10:43 AM
quote:On Bob Johnstone's web site there is the part number for the solid state module to install under your old can.


Mr. Bove:
Contrary to JDP's reference, it would probably be better to install the solid state device under the old Prestolite cover.

Have you found the Studebaker chambered exhaust article yet?

Best regards as always,
Geno Robino



http://www.electro-dynamics.com/chassis/AVframe3lil.jpg
1963 Studebaker Avanti: C4 Corvette narrowed front/rear suspension, C5 13" calipers/rotors adapted to C4, Viper differential with Intrax 3.54 ratio (the snake has been charmed!), coil overs, stainless tubular frame, stainless chambered side exhaust.
Here are two links for some pictures and information.
Slide Show (http://www.electro-dynamics.com/chassis/avantislide.html)
Magazine Article (http://www.electro-dynamics.com/magazine.html)