PDA

View Full Version : Flywheel identification - Hollander?



PackardV8
03-10-2008, 04:01 PM
Greetings, SDCrs,

I was sold a flywheel which, "guaranteed, it came off a Studebaker or a Packard V8, cause that's all Dad had." It doesn't seem to fit either. Would appreciate some help identifying this flywheel:

15.5" diameter
184 teeth
2.5" center hole
4.5" bolt circle
2.125" c/c
43# weight
drilled for two different clutch covers

thnx, jack vines




PackardV8

Skip Lackie
03-12-2008, 08:58 AM
I checked a couple of Hollanders and they do not describe the dimensions of flywheels -- just what will interchange with what. Not surpisingly, Stude and Packard flywheels do not interchange with anything else (except of course for where Packard engines were used in Hudson and Nash).

Skip Lackie
Washington DC

Skip Lackie
03-12-2008, 08:58 AM
I checked a couple of Hollanders and they do not describe the dimensions of flywheels -- just what will interchange with what. Not surpisingly, Stude and Packard flywheels do not interchange with anything else (except of course for where Packard engines were used in Hudson and Nash).

Skip Lackie
Washington DC