PDA

View Full Version : Looking for a +.030 Champion piston, used.



gordr
08-02-2017, 11:55 PM
Just like the post title. I need one or more thirty thou oversize pistons for a '50 to '54 Champion 170. I tore down a 1950 170 that was given to me, and one piston was stuck so badly, I damaged it taking it out. I think the bore can be saved. Crank, bearings, and cam all look good. I figure one replacement piston, and new rings, and that engine could be made whole again.

A single +.040 piston would be fine, too. I could have the one cylinder bored to fit it.

Ron Dame
08-03-2017, 07:16 AM
I'll check my pile this weekend, if i recall, mine are 0.020, but it's been a while. they might be bigger

Ron Dame
08-03-2017, 04:51 PM
Sorry Gord, mine are .020 over

dannyo
08-03-2017, 05:59 PM
i will pm you , dannyo.